ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Removal and Replacement|Page 7546 > < Removal and Replacement|Page 7544
Page 7
background image

19. Prove out the SRS as follows:

Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the
air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS
fault is present, the air bag warning indicator will:
-

fail to light.

-

remain lit continuously.

-

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will
sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.

Clear all continuous DTCs from the RCM and OCSM using a scan tool.

60 Percent

SEAT BACKREST - SECOND ROW, 60 PERCENT

Exploded View

Removal and Replacement|Page 7546 > < Removal and Replacement|Page 7544