Taurus X FWD V6-3.5L (2008)
Taurus X Rear Seat Cushion, Second Row, 60 Percent (Part 2)
Removal and Installation
1. Remove the head restraint.
2. With the backrest folded down, release the backrest trim cover lower J-clip.
3. Separate and remove the outer pivot cover.
4. Release the 2 backrest trim cover inside J-clips to hard back panel.
5. If equipped, disconnect the backrest heater mat electrical connector and route through the backrest trim cover.
6. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn
from the seat backrest foam.
Release the hook-and-loop strips, invert the backrest trim cover and remove the 3 rows of hog rings.
7. Release the hook-and-loop strips and invert the backrest trim cover to the top of the backrest.
8. NOTE: The head restraint guides are not interchangeable.
Lift the backrest foam pad, squeeze the tabs in and remove the 2 head restraint guides.
9. Remove the backrest trim cover.
10. To install, reverse the removal procedure.
60 Percent
SEAT CUSHION COVER - SECOND ROW, 60 PERCENT
Exploded View
