Taurus X FWD V6-3.5L (2008)
Bench Seat Cushion (Part 2)
Removal and Installation
1. NOTE: If damaged when removed, install new plastic rivets.
Remove the 2 rivets and pull the cushion handle out of the pocket.
-
Using an appropriate tool, from under the rivet head, pry the rivet up.
-
When removing the plastic rivet, make sure not to get under the insert or the rivet will not come out.
-
Another method that can be used to remove the plastic rivets is to drive a screw partially into the rivet head and pull the screw and rivet head
out. This will require new plastic rivets be installed.
2. Separate the pivot release cable and casing and remove the pivot release handle.
