Taurus X FWD V6-3.5L (2008)
14. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
Inspect the occupant classification sensor (OCS) assembly, seat cushion frame and support assembly for any foreign objects before
installing the OCS assembly to the seat cushion frame. If any foreign objects are found, remove them. Failure to follow these
instructions may result in incorrect OCS system operation or failure.
-
Failure to route the OCS system components through the correct seat cushion support opening may cause component failure.
-
While positioning the seat cushion frame and occupant classification sensor (OCS) assembly, be careful not to damage any of the
components. Failure to do so may result in component failure.
Position the OCS bladder to the cushion frame.
-
Feed the pressure sensor and hose through the center opening in the cushion frame wires.
15. Install the OCS bladder pin-type retainers.
All seats
16. NOTE: Make sure the pressure sensor is correctly installed and retained to the seat track bracket and the pressure sensor hose is not kinked
during installation.
Install the seat track.
17. Install the front seat backrest.
18. Install the seat.
19. Repower the SRS. Do not prove out the SRS at this time.
