Taurus X FWD V6-3.5L (2008)
10. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The
recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this
instruction may result in serious personal injury.
NOTE: Note cable routing for installation.
Remove the 3 cables from the LH recliner and route them out of the seat cushion frame.
11. Remove the 2 bolts and the LH recliner.
-
To install, tighten to 50 Nm (37 lb-ft).
12. Remove the 3 outboard cushion frame-to-riser nuts.
-
To install, tighten to 23 Nm (17 lb-ft).
13. Remove the cushion frame-to-riser bolt in front of the RH recliner.
-
To install, tighten to 50 Nm (37 lb-ft).
14. Remove the cushion frame yoke-to-riser bolt.
-
To install, tighten to 50 Nm (37 lb-ft).
15. Remove the 3 RH recliner-to-riser bolts and separate the cushion frame from the riser.
-
To install, tighten to 50 Nm (37 lb-ft).
16. Remove the 2 bolts, route out the cable and remove the LH latch foot.
-
To install, tighten to 50 Nm (37 lb-ft).
17. Remove the 2 bolts, route out the cable and remove the RH latch foot.
-
To install, tighten to 50 Nm (37 lb-ft).
18. Remove the bolt and the safety belt buckle.
-
To install, tighten to 37 Nm (27 lb-ft).
19. Remove the screw and the inner pivot cover.
20. Remove the pivot grommet.
21. Remove the screw and the stationary foot cover.
22. Remove the pin-type retainer, screw and the RH recliner cover.
23. NOTE: Note cable routing for installation.
Remove the cushion frame yoke-to-RH recliner bolt, route out the cable and remove the RH recliner.
-
To install, tighten to 50 Nm (37 lb-ft).
24. Remove the cushion trim cover from the cushion foam pad.
25. CAUTION: When installing the backrest frame, make sure to follow the torque sequence or damage to the components may occur.
To assemble, reverse the disassembly procedure.
