Taurus X FWD V6-3.5L (2008)
All seats
5. Release the outer and inner J-clips at the rear of the cushion trim cover.
6. Release the 2 cushion trim cover side retainers and remove from between the cushion frame and seat track.
-
Un-curl the retainer ends and push through the opening between the cushion frame and riser/seat track.
7. Remove the cushion trim cover and cushion foam pad assembly.
8. Remove the screw and recliner handle.
Power-fold seat
9. Remove the outer recliner cover.
-
Remove the recliner cover screw.
-
Release and separate the outer and inner recliner covers.
-
Route the backrest release pull strap through the cover opening.
10. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The
recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this
instruction may result in serious personal injury.
NOTE: Note cable routing and orientation for installation.
With the recliner in the released (folded) position, detach the 3 cables.
-
Disconnect the power-fold seat motor cable from the recliner.
-
Rotate the cable end guide to release.
-
Disconnect the cable jacket from the cable clamp.
-
Detach the inboard and outboard latch cable jackets from the retainers.
-
Un-hook the inboard and outboard latch cable ends.
