Taurus X FWD V6-3.5L (2008)
RH rear bleeder screw.
^
Press and release the parking brake 5 times.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
5. Tighten the RH rear bleeder screw to 10 Nm (89 lb-in), remove the rubber hose and install the bleeder screw cap.
6. Repeat Steps 2 through 5 for the LH rear brake caliper.
7. Remove the RH front bleeder cap and place a box-end wrench on the bleeder screw. Attach a rubber drain tube to the RH front bleeder screw and
submerge the free end of the tube in a container partially filled with clean, specified brake fluid.
8. Have an assistant hold firm pressure on the brake pedal.
9. Loosen the RH front bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the
RH front bleeder screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
10. Tighten the RH front bleeder screw to 12 Nm (9 lb-ft), remove the rubber hose and install the bleeder screw cap.
11. Repeat Steps 7 through 10 for the LH front brake caliper bleeder screw.
