Taurus X FWD V6-3.5L (2008)
Disc Brake System - Exploded View (Part 2)
Removal
1. Remove the brake pads.
2. Remove and discard the 2 brake caliper anchor plate bolts and remove the brake caliper anchor plate.
^
Make sure the steering stop is supported when the brake caliper anchor plate bolts are removed.
3. NOTE: Do not remove the anchor plate guide pins. The guide pins are press fit to the brake caliper anchor plate. If the guide pins are damage a
new anchor plate must be installed.
Inspect the brake caliper anchor plate assembly.
^
Check the guide pins and boots for binding or damage.
^
Install a new brake caliper anchor plate if it is worn or damaged.
Installation
1. Position the brake caliper anchor plate and steering stop on the wheel knuckle and install 2 new bolts.
^
Tighten to 150 Nm (111 lb-ft).
2. Install the brake pads.
