Taurus X FWD V6-3.5L (2008)
Install the RH VCT housing and the 3 bolts.
^
Tighten in the sequence shown to 10 Nm (89 lb-in).
13. Install the engine front cover.
14. Install the RH cylinder block drain plug or, if equipped, the block heater.
^
Tighten the cylinder block drain plug to 20 Nm (15 lb-ft).
^
Tighten the block heater to 40 Nm (30 lb-ft).
15. CAUTION: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the
wiring may occur.
If equipped, connect the block heater electrical connector and install the heat shield.