Taurus X FWD V6-3.5L (2008)
4. Using the special tool, remove the crankshaft pulley.
Installation
1. Lubricate the crankshaft front seal inner lip with clean engine oil.
2. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
Using the special tools, install the crankshaft pulley.
3. Using the special tool, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
^
Stage 1: Tighten to 120 Nm (89 lb-ft).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 lb-ft).
^
Stage 4: Tighten an additional 90 degrees.