Taurus X FWD V6-3.5L (2008)
Install the remaining engine front cover bolts.
Tighten all of the engine front cover bolts and engine mount bracket bolts in the sequence shown in 2 stages:
^
Stage 1: Tighten bolts 1 thru 22 to 10 Nm (89 lb-in) and bolts 23, 24 and 25 to 15 Nm (11 lb-ft).
^
Stage 2: Tighten bolts 1 thru 22 to 24 Nm (18 lb-ft) and bolts 23, 24 and 25 to 75 Nm (55 lb-ft).
10. Using the floor jack, lower the engine to the installed position.
11. Install the new O-ring seals and the A/C tubes-to-evaporator and the bolt.
^
Tighten to 15 Nm (11 lb-ft).
12. Install the A/C tube retaining clamp bolt.
^
Tighten to 10 Nm (89 lb-in).
