Taurus X FWD V6-3.5L (2008)
Alignment: Service and Repair
Toe Adjustment - Front
Toe Adjustment - Front
1. Using alignment equipment and the manufacturer's instructions, measure the front toe.
2. Start the engine and center the steering wheel.
3. Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
4. Remove the steering gear bellows clamps.
5. Loosen the nuts.
6. NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.
Rotate the tie rods as necessary to adjust the toe setting.
7. Tighten the nuts to 80 Nm (59 lb-ft).
8. Install the steering gear bellows clamps.
9. Recheck the toe settings and adjust as necessary.
