Taurus X FWD V6-3.5L (2008)
Catalytic Converter: Service and Repair
Catalytic Converter
Catalytic Converter
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the 2 exhaust Y-pipe flange nuts.
^
Discard the gasket.
^
To install, tighten to 40 Nm (30 lb-ft).
3. Loosen the Torca clamp nut.
^
To install, tighten to 55 Nm (41 lb-ft).
4. Separate the catalytic converter from the muffler and tailpipe and remove the catalytic converter.
5. To install, reverse the removal procedure.
^
Always install new gaskets and exhaust fasteners.
6. Start the engine and check for exhaust leaks.
