Taurus X FWD V6-3.5L (2008)
1. Position the seat to its most forward position.
2. Remove the lower B-pillar trim panel.
3. Lower the upper B-pillar trim panel from the headliner.
-
Remove the screw cover and screw at the top of the upper B-pillar trim panel.
-
Pull the bottom of the B-pillar trim panel to release the lower retainer clips.
-
Lower the upper B-pillar trim panel from the headliner.
4. Remove the D-ring bolt and position aside the D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the safety belt shoulder height adjuster bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
6. Rotate the safety belt shoulder height adjuster and unhook from the B-pillar.
7. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
8. Check the active restraint system for correct operation.