Taurus X FWD V6-3.5L (2008)
NOTE:
-
Vehicle with auxiliary climate control shown, vehicle without auxiliary climate control similar.
-
LH shown, RH similar.
1. Remove the rear quarter trim panel.
2. Remove the D-pillar trim panel from the safety belt.
3. Remove the safety belt D-ring bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
4. Remove the secondary safety belt guide from the D-pillar.
5. Remove the bolt and safety belt retractor.
-
To install, tighten to 48 Nm (35 lb-ft).
6. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
The web loop portion of the anchor must face outboard of the vehicle.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.
