Taurus X FWD V6-3.5L (2008)
8. NOTE: Support the knuckle with a suitable jackstand.
Pull the knuckle outboard and rotate it toward the rear of the vehicle.
9. Remove the 2 bearing support nuts.
Installation
NOTE: A new power transfer unit (PTU) shaft seal must be installed whenever the intermediate shaft is removed.
1. Position the assembly in the vehicle, aligning the splines on the intermediate shaft with the transmission splines.
2. Install the 2 intermediate shaft support bearing nuts.
^
Tighten to 25 Nm (18 lb-ft).
