Tempo L4-122 2.0L DSL (1984)
Seat Track: Customer Interest
Driver's Power Seat - Rocks Fore and Aft
Article No. 85-8-1
POWER SEAT - DRIVER'S - ROCKS FORE AND AFT DURING BRAKING AND ACCELERATION
FORD 1984 TEMPO, 1983-84 THUNDERBIRD, LTD
LINCOLN-MERCURY 1984 MARK VII, CONTINENTAL, TOPAZ, 1983-84 MARQUIS, COUGAR
Customer reports of the driver's seat rocking fore and aft excessively during vehicle braking and acceleration can be serviced by installing a new power
seat track assembly of a new design using the repair procedure shown below:
1.
Depending on the carline application, obtain the appropriate power seat track assembly as indicated below:
MARK VII VEHICLE APPLICATIONS - 1984 E5LY-6361711-A Track Assembly - Front Seat (less motor)
(Driver seat applications)
1 per vehicle
CONTINENTAL VEHICLE APPLICATIONS - 1984 E55Y-5461711-A Track Assembly - Front Seat (less motor)
(Driver seat applications)
1 per vehicle
THUNDERBIRD/COUGAR, LTD/MARQUIS VEHICLE APPLICATIONS - 1983-84 E5DZ-5461711-A Track Assembly - Front Seat
(less motor)
(Driver seat applications)
1 per vehicle
TEMPO/TOPAZ VEHICLE APPLICATIONS - 1984 E53Z-5461711-A Track Assembly - Front Seat (less motor)
(Driver seat applications)
1 per vehicle
2.
Adjust the driver's seat and track assembly to the full up (vertical) and full forward (horizontal) positions.
3.
Remove the driver's seat and track assembly from the vehicle as outlined in Section 41-08 of the appropriate Car Shop Manual.
4.
Remove the seat belt buckle/seat belt buckle and support assembly from the track assembly (if so equipped). Refer to Section 41-50 of the
appropriate Car Shop Manual.
5.
Remove the four (4) screws retaining the seat track to the seat cushion (refer to Section 41-08 of the appropriate Car Shop Manual).
6.
Transfer the power seat track motor and drive cables to the new power seat track assembly as outlined in Section 41-08 of the appropriate Car
Shop Manual.
7.
Install the seat track to the seat cushion frame. Torque the four (4) attaching screws as specified in Section 41-08 of the appropriate Car Shop
Manual.
8.
Install the seat belt buckle/seat belt buckle and support assembly to the seat track (if so equipped). Torque the attaching bolts and/or nut and
washer assemblies as outlined in Section 41-50 of the appropriate Car Shop Manual.
9.
If the seat is equipped with an inertia seat back latch, check the latch for proper operation (sensitivity test) before installing the seat in the vehicle
as follows:
^
With the seat and track assembly positioned on a flat surface, grasp the seat cushion only and slowly tilt the seat assembly forward enough to
cause the seat to tilt forward (via gravity).
^
The latch should engage at this point (approximately 11 degrees from original position) restricting the seat back from tilting to its full forward
position.
^
If the latch does not lock replace it.
10.
Install the driver's seat and track assembly in the vehicle using the previously removed screws and/ or nut and washer assemblies. Refer to Group
41- 08 of the appropriate Car Shop Manual.
NOTE :
Be sure to torque all attachments to specifications.
11.
Check the seat tracks and seat belts for proper operation.
PART NUMBER
PART NAME
CLASS
E53Z-5461711-A
Tempo/Topaz Applications
C
