Tempo L4-122 2.0L DSL (1984)
Figure 16
Correction:
Remove belt moulding and apply two layers of 1/4"x3/4"x12" long tape to underside of belt moulding as shown in Figure 16.
5.
Concern: Early built units did not include a foam tape patch over weld access holes in the front door inner panel.
Figure 17
Correction:
Remove the door trim panel and apply 1/4"x3/4" foam tape over the weld access holes as shown in Figure 17.
NOTE:
(2) Access holes on two-door models and (1) Access hole on four-door models.
LTD/MARQUIS
CROWN VICTORIA/GRAND MARQUIS
6.
Concern: Existing slits in the corners of the flocked run cause wind noise.
^
Upper front corner at vent window division bar.
^
Upper rear corner.
