Tempo L4-122 2.0L DSL (1984)
Figure 29
HALFSHAFT INSTALLATION
7.
Refer to Figure 29.
Install new circlips on the inboard CV joint stub shafts.
The outboard CV joint stub shaft does not have a circlip.
NOTE:
To install the circlip properly, start one end in the groove and work the circlip over the stub shaft end and into the groove. This will avoid
over-expanding the circlip.
CAUTION: The circlip must not be reused. A new circlip must be installed each time the inboard CV joint is installed into the transaxle
differential.
Figure 30
8.
Refer to Figure 30.
Carefully align the splines of the inboard CV joint stub shaft with the splines in the differential. Exerting some force, push the CV joint into the
differential until the circlip is felt to seal in the differential side gear.
Use care to prevent damage to the differential oil seal.
CAUTION: Install shipping plug T81P-1177-B or equivalent to assure alignment of CV joint stub shaft with side gear.
NOTE:
A non-metallic mallet may be used to aid in seating the circlip into the differential side gear groove. If a mallet is necessary, tap only on the
outboard CV joint stub shaft.
