Tempo L4-122 2.0L DSL (1984)
10.
Remove the plastic window guides if broken/cracked (E3FZ-61222A92-A Lower) and/or (E3FZ- 6122362-A Upper) from the glass bracket as
required and replace with new parts.
11.
Reinstall the tube run into the glass bracket and install both parts as an assembly into the door. (It may be necessary to remove the stabilizer at the
belt line to do this).
12.
Loosely install the upper and lower nut and washer assemblies into the tube run and door inner panel (also stabilizer-22336) at door belt.
13.
Install the regulator arm roller guide into the glass bracket "C" channel.
14.
Snap the plastic retainer and spacer (removed in Step #9 above) into the new door glass and install the glass into the door through the door belt.
NOTE:
Assure that the metal washer within the plastic retainer assembly is on the outboard side of the glass.
15.
Position glass to glass bracket and install (2) rivets (385189-S100) to secure glass to glass bracket.
16.
Raise the glass approximately 3/4" up and pull the glass back into the "B" pillar glass run. Set stabilizer (22336) to glass and tighten screw.
17.
Tighten the upper and lower nut and washer assemblies attaching the tube run to the inner panel. Torque to 7-11 N-m (5-8 ft.lbs.).
18.
Cycle the door glass to assure smooth cycle.
19.
Reinstall door water shield and trim panel.
PART NUMBER
PART NAME
CLASS
E43Z-5421572-B
Front Retainer (Rt)
C
E43Z-5421573-B
Front Retainer (Lt)
C
E3FZ-61222A92-A
Bushing Lower Guide
B
E3FZ-6122362-A
Bushing Upper Guide
B
385189-S100
Rivet
BR
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP21432A83
TIME:
0.5 Hr.
Additional Time to Replace Glass:
SP21432B83 0.3 Hr.
Additional Time to Replace Guide:
SP21432C83 0.2 Hr.
DLR. CODING: Basic Part No. 70214A32 Code: 79
SPECIAL INSTRUCTIONS: Parts will be available 9-2-83