Tempo L4-140 2.3L CFI (1985)
Figure 2
Figure 3
^
Have a bead about 0.2" (5 mm) wide by 0.25" (6 mm) high, above the pan surfaces, in both front and rear half-rounds, Figures 2 and 3.
^
Have a bead about 0.2" (5 mm) wide by 0.15" (4 mm) high, above the oil pan surfaces, along the rails, Figures 2 and 3.
NOTE: BE SURE THAT THE GROOVE IS COMPLETELY FILLED WITH RTV. MAKE CERTAIN THAT NO AIR IS TRAPPED IN THE
GROOVE BECAUSE A BLOW OUT OF THE RTV MAY OCCUR WHEN THE ENGINE IS HEATED UP DURING NORMAL ENGINE
OPERATIONS.
^
Have the nozzle of the RTV tube slightly above the oil pan groove.