Tempo L4-140 2.3L CFI (1985)
NOTE:
Compressor and engine must be cooled down prior to check by hand.
If air gap is set correctly, make sure compressor will turn easily by hand. If compressor does not turn easily, replace compressor using the
instructions in the appropriate Car Shop Manual, Section 36-47-37.
c.
Low Voltage (10.5 Volts or Less) - Install a clutch coil jumper assembly and relay using the following procedure.
Figure 24
Clutch Coil Jumper Assembly and Relay
Installation - 1984 Models Only
1.
Drill a 1/8 inch hole in right front splash shield near base of strut tower, Figure 24. Install relay (E3TZ-9345-A) with a suitable screw.
NOTE:
Relay connector should be positioned facing inboard.