Tempo L4-140 2.3L CFI (1985)
Engine Control Module: All Technical Service Bulletins
Engine - High Idle Speed/Stalling
Article No. 86-12-8
IDLE SPEED - ADAPTIVE LEARNING STRATEGY - 2.3L HSC CFI
FORD 1985-86 TEMPO
LINCOLN-MERCURY 1985-86 TOPAZ
High idle speed, stalling or other driveability symptoms may still be present after a defective component has been replaced. This may mean that the
Adaptive Strategy must be reset in the EEC IV processor. The reset procedure should be performed for any of the following reasons:
^
On new vehicles.
^
When the battery has been disconnected during normal service.
^
When an EEC component is replaced or an adjustment is made. (Example: Hard Stop RPM)
The procedure to reset Adaptive Idle Speed Control is as follows:
1.
Disconnect battery for 10-15 minutes.
2.
Reconnect battery, start engine and bring to normal operating temperature (upper radiator hose hot and pressurized).
3.
Set parking brake and place foot on service brake.
4.
Place transmission in Drive (ATX) or Neutral (MTX), steering in the "straight ahead" position.
5.
Place all accessories in the Off position. A/C Off and the mode selector lever, located on A/C panel, set in the "floor" position.
6.
When the engine RPM reaches the Adaptive Idle Speed (refer to the following application chart), let the engine idle for 2 minutes.
NOTE:
The vehicle can be driven to check for customer concerns. This will start the learning process for Adaptive Fuel Control.
OTHER APPLICABLE ARTICLES: Supersedes 85-9-17
WARRANTY STATUS: "INFORMATION ONLY"
(See chart on next page)
CALIBRATION APPLICATION CHART
Processor
Replaced
Hard Stop
Adaptive/"Learned"
Calibration
Engine
(12A650)
By
Idle Speed
Idle Speed
1985 M
5-25F-R0
(49S) Base
E53Z-HB/HC
E63Z-VB
640 RPM in Neutral
750 RPM in Neutral
5-25F-R10
(49S) Base
E53Z-HC/HD
E63Z-VB
640 RPM in Neutral
750 RPM in Neutral
5-25Q-R0
(Calif) Base
E53Z-GB/GC
E63Z-XB
640 RPM in Neutral
750 RPM in Neutral
5-25Q-R10
(Calif) Base
E53Z-GC/GD
E63Z-XB
640 RPM in Neutral
750 RPM in Neutral
5-25C-R01
(49S) Plus (HO)
E53Z-KA/KB
640 RPM in Neutral
800 RPM in Neutral
5-25P-R0
(Calif) Plus (HO)
E53Z-MA/MB
640 RPM in Neutral
1100 RPM in Neutral
1985 ATX
5-26E-R0
(49S) Base
E53Z-DB/DC
E63Z-TF
590 RPM in Drive
600 RPM in Drive
5-26E-R10
(49S) Base
E53Z-DC/DD
E63Z-TF
590 RPM in Drive
600 RPM in Drive
5-26E-R21
(49S) Base
E63Z-TE/TF
625 RPM in Drive
656 RPM in Drive
5-26J-R01
(49S) Base
E53Z-DB/DC
E63Z-TF
590 RPM in Drive
600 RPM in Drive
5-26J-R11
(49S) Base
E53Z-DC/DD
E63Z-TF
590 RPM in Drive
600 RPM in Drive