Tempo V6-182 3.0L (1993)
Brake Switch (Cruise Control): Testing and Inspection
Perform this test only when the brake application will not disconnect the speed control system.
1.
Check operation of stop lamps by applying approximately 6 lbs. of effort to the brake pedal. If more than 6 lbs. is required, check brake pedal
actuation and stop lamp switch.
2.
If stop lamps do not function properly, the stop lamp switch, circuit fuse or bulbs must be checked.
3.
If stop lamps function properly, check for battery voltage on white/purple wire (circuit 296) at the 6-way connector.
4.
Depress brake pedal until stop lamps are lit.
5.
On all models except Escort, Tempo and Topaz, check voltage on dark/green stripe lead at the 6-way connector. The difference between this
and the voltage reading in step 3, must not exceed 1.5 volts.
6.
On Escort, Tempo and Topaz, check voltage on red/light green lead at the 6-way connector. The difference between this and the voltage reading
in step 3, must not exceed 1.5 volts.
7.
If the voltage difference is greater than 1.5 volts, a high resistance in the circuit exists which must be found and corrected.
8.
Perform VACUUM DUMP VALVE TEST.
