Tempo V6-182 3.0L (1993)
3. Ensure injector cups are clean and free of contamination or damage.
4. Install fuel injectors in fuel injection supply manifold using light twisting-pushing motion.
NOTE: Prior to installation perform the following steps:
^
Lift distributor enough to allow fuel injection supply manifold crossover tube to clear distributor housing and lower intake manifold and
position fuel injection supply manifold.
^
Lower distributor into position.
^
Install distributor hold-down bolt and align scribe marks. Tighten hold-down bolt to 23-34 Nm (17-25 lb ft).
5. Carefully install fuel injection supply manifold assembly and fuel injectors into lower intake manifold, one side at a time. To ensure that O-rings
are seated, push down on fuel injection supply manifold.
6. While holding fuel injection supply manifold in place, install four retaining bolts and tighten to 8-12 Nm (71-106 lb in).
7. Connect spring lock coupling fuel supply (1/2 inch) and fuel return (3/8 inch) lines.
8. Before connecting the fuel charging wiring harness, turn the ignition switch to the ON position several times. This will pressurize the fuel system.
9. Using a clean paper towel, check for leaks where the fuel injectors connect to the fuel injection supply manifold. If leaks are detected, service as
required.
10. Connect the fuel charging wiring harness to the fuel injectors.
11. Connect vacuum line to fuel pressure regulator.
12. Install throttle body.
