Tempo FWD L4-140 2.3L HSO (VIN S) (1989)
/Page-1072002.png)
b. Install quick disconnect and a 0-100 psi (0-700 (kPa) gauge, then start vehicle and place gear selector in drive.
c. TV pressure should be within 0-5 psi (0-12 kPa) at idle. If zero (0) psi is read, verify gauge is functioning by moving throttle to increase
engine rpm.
d. If TV pressure is not within 0-5 psi, repeat adjustment procedure.
5. If TV pressure is still not 0-5 psi, perform the following procedure:
a. Disconnect TV cable at transaxle TV lever. Push TV to hard set position. If TV pressure is within 0-5 psi, continue with following
procedure. If TV pressure is not within the 0-5 psi range, refer to Diagnosis and Testing.
b. Inspect for proper TV cable routing.
c. Inspect for proper installation of cable in TV bracket, ensure cable is secure in bracket and cable tabs are locked into the bracket.
d. Inspect for proper installation of TV cable at the accelerator bracket.