Thunderbird V6-232 3.8L SC (1989)
Assembly
1.
Install secondary piston assembly into bore, spring end first.
2.
Install primary piston assembly, spring end first.
3.
Depress primary piston and install snap ring.
4.
On front wheel drive models, install fluid control valve and torque to 97-115 inch lbs.
5.
Lubricate new grommet with brake fluid and install in primary port.
6.
Install reservoir in new grommet.
7.
On all models, fill and bench bleed master cylinder. Refer to Brake Bleeding.
8.
Install cap and diaphragm on master cylinder reservoir.
Removal and Installation
1.
Disconnect brake lines from master cylinder, then all necessary electrical connectors.
2.
Remove nuts retaining master cylinder to brake booster.
3.
Remove master cylinder.
4.
Reverse procedure to install. After installation is complete, fill master cylinder with manufacturer recommended brake fluid and perform brake
bleeding procedure.
