Thunderbird V6-232 3.8L SC (1989)
Suspension Strut / Shock Absorber: Service and Repair
Rear
Rear Suspension
Shock Absorber Replacement
These vehicles are equipped with gas pressurized rear shock absorbers which will extend unassisted. Do not apply heat or flame to shock tube
during removal.
1.
Position vehicle on drive-on hoist or alignment pit, so that rear suspension arms are supported during removal.
2.
Remove all upper attaching parts from inside of luggage compartment, Figs. 14 and 15.
3.
Remove attaching bolt and at lower arm, then remove shock absorber.
4.
Reverse procedure to install. Tighten to specifications.