Thunderbird V6-232 3.8L SC (1989)
2.
Using a plastic or wood (non-metal) scraper, remove as much of the sealer from the inside of the front and/or rear glass (Thunderbird only) and
side edges as possible. Use care not to scratch the glass or the ceramic paint on the glass. It is not necessary to remove all the sealer, just the large
deposits that will interfere with the installation of the foam seal used in this procedure. Use mineral spirits to remove any residue from the glass.
Refer to Figure 1.
NOTE:
CLEAN AFFECTED INTERIOR TRIM WITH FORD SPOT AND STAIN REMOVER (B7A-19521-AA OR EQUIVALENT).
3.
Remove any heavy deposits of sealer from the interior trim components and then install the headliner, A-pillar trim mouldings and quarter trim
mouldings (if removed), but do not tighten the attaching screws.