Thunderbird V8-281 4.6L SOHC (1994)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor
Front
1.
Raise and support vehicle.
2.
Disconnect sensor electrical connector.
3.
Remove routing clips along wiring harness.
4.
Remove bolt securing sensor to front spindle.
5.
Remove front wheel sensor.
6.
Reverse procedure to install.
Rear
1.
Locate wheel sensor electrical connector inside luggage compartment, rearward of wheel well behind carpeting. Disconnect sensor connector
2.
Lift luggage compartment carpet and push sensor wire grommet through hole in luggage compartment floor.
3.
Remove plastic clip holding sensor wire to axle carrier housing.
4.
Remove wheel sensor retaining bolt and sensor.
5.
Reverse procedure to install. Torque sensor retaining bolt to 14-20 ft. lbs.
