Thunderbird V8-302 5.0L HO (1992)
Connect A Hose To The Drain Tube.
33.
Connect a 1/2" (12.7 mm) outside diameter hose (E8UZ-19K592-A) to the drain tube using a small hose clamp (376240-S100), Figure 6.
34.
Install the evaporator case in the vehicle by reversing the removal procedure.
a.
Drill a hole in the cowl panel to accommodate the new drain tube. See Figure 2 for location. The hole should be about 2" (50.8 mm) below
the regular evaporator case drain tube.
b.
After the new drain tube is through the hole and in permanent position, seal around the tube with body sealer (F1AZ-19562-A).
35.
Recharge the A/C system and check the operation of the system.
36.
Reset radio stations recorded in step # 1.
NOTE: CHECK THE OPERATION OF ALL COMPONENTS AFTER ASSEMBLY IS COMPLETED.
NOTE:
IF EVAPORATOR CORE AND HOUSING ASSEMBLY IS REPLACED PER THIS TSB ARTICLE, IT WILL NOT BE NECESSARY TO
PERFORM TSB 94-2-9.
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 92-12-8
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1992/94 Models; Basic Warranty Coverage For All Other Models
OPERATION DESCRIPTION
TIME
940212A
Remove And Replace
4.5 Hrs.
Evaporator Case
DEALER CODING
BASIC PART NO.
CONDITION CODE
19850
08
OASIS CODES: 208000, 208300, 208999