Thunderbird V8-302 5.0L HO (1992)
1. Remove rear seat back and cushion.
2. Remove nut and buckle or belt assembly from vehicle.
3. Pry off brass grommet from assembly and discard.
4. To install, line up two anchor tabs on stud and install nut. Tighten nut to 30-40 Nm (23-29 lb-ft).
5. Install rear seat cushion.
Safety Belt Without Anchorage Plate Thread Damage
The lap/shoulder safety belts are factory installed in their proper locations. If the belts are removed for any reason, they should be installed using proper
service procedures. The 7/16 x 20 Torx(r) head anchor bolts must be hand started and then tightened to 30-40 Nm (23-29 lb-ft).
1. Remove the damaged bolt from the anchor reinforcement and discard.
Parts Replacement Chart
2. Install a new bolt and hand tighten. Refer to Parts Replacement Chart for part number. Tighten to 30-40 Nm (23-29 lb-ft).
Safety Belt With Anchorage Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchorage plate with a 27/64-inch drill.
3. Rethread the anchorage plate with a 1/2-13 tap.
4. Blow out the chips.