Thunderbird V8-302 5.0L HO (1992)
Seat Belt Retractor: Service and Repair
Passive Restraint System (Motorized Seat Belts)
Drive Belt
REMOVAL
1. Cycle shoulder belt to full forward position. Disengage shoulder belt from mini buckle.
2. Remove rear seat back and cushion.
3. Remove A-pillar and quarter panel trim.
4. Disconnect electrical connectors from A- and B-pillars limit switches.
5. Remove upper bolt used to retain vertical belt guide to inner quarter panel.
6. Using release tab, disengage vertical belt guide from B-pillar bracket.
7. Remove two bolts retaining track assembly to B-pillar.
8. Remove A-pillar limit switch bracket attaching screws.
9. While holding track assembly securely, remove two bolts retaining track assembly to roof rail.
10. Rotate track assembly downward at rear to disengage A-pillar limit switch bracket from A-pillar.
11. While holding track assembly, rotate thumb wheel on motor counterclockwise to allow tape to disengaged from motors drive gear.
12. Remove track assembly from vehicle, then remove A-pillar limit switch bracket from track assembly.