| Removal and Installation Removal CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. | | -
Release the parking brake. | | | -
Remove the wheel and tire.
For additional information, refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
| | | -
Remove the brake drum. - Remove and discard the retainer (if equipped).
| | | -
Hold the wheel cylinder pistons in place with a rubber band. | | | -
Remove the hold down springs. | | | -
CAUTION:Do not damage the wheel cylinder boots. Detach the brake shoes from the wheel cylinder. | | | -
CAUTION:Cap the brake tube to prevent fluid loss and dirt ingress. Remove the wheel cylinder. - Remove the bleed nipple dust cap.
- Disconnect the brake tube.
- Remove the bolts.
| Installation | | -
To install, reverse the removal procedure. | | | -
Bleed the brake system.
For additional information, refer to: Brake System Bleeding (206-00 Brake System - General Information, General Procedures).
| | | -
Depress the brake pedal to adjust the brake shoes. | | |
