Removal and Installation Removal All vehicles | -
Remove the battery. For additional information, refer to Battery in this section. | | -
Remove the driver seat. For additional information, refer to Section 501-10 Seating. | Vehicles with 2.4L diesel engine All vehicles | -
Remove the parking brake control retaining bolts. | | -
Detach the floor covering and remove the seat pedestal retaining bolts. | | -
Detach the floor covering and remove the battery to jump start point cable retaining screws. | | -
CAUTION:Do not apply excessive force to the seat pedestal. Detach the battery to jump start point cable from the seat pedestal. | | -
Detach the floor covering and detach the battery to jump start point cable from the retaining clips. | | -
Remove the jump start point cover. | | -
Disconnect the battery to jump start point cable from the jump start point. | | -
Detach the battery to jump start point cable from the retaining clip. | | -
Detach the battery to jump start point cable from the retaining clip. | | -
NOTE:The battery to jump start point cable is routed through a rubber grommet in the bulkhead. Remove the battery to jump start point cable. | Installation | -
To install, reverse the removal procedure. | |