Transit Connect L4-2.0L (2010)
5. Under the front of the seats, connect the seat electrical bulkhead connectors and tighten the bolt.
6. Install RCM fuse 162 (7.5A) to the CJB.
7. Connect the battery ground cable.
8. Turn the ignition from OFF to ON.
9. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable. For additional information, refer to Battery.
10. Prove out the SRS as follows:
Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the air bag warning indicator with the air bag
modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS fault is
present, the air bag warning indicator will:
- fail to light.
- remain lit continuously.
- flash.
The air bag warning indicator may not illuminate until approximately 30 seconds after the ignition has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the RCM. If the air bag warning indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be
diagnosed and repaired.
Clear all CMDTCs from the RCM and Occupant Classification System Module (OCSM) using a scan tool.
