Transit Connect L4-2.0L (2010)
Body Control Module: Service and Repair
Generic Electronic Module (GEM)
Removal
NOTE: A new Generic Electronic Module (GEM) is delivered in a "manufacturing mode" with a pre-set DTC. A successful configuration of the GEM,
then a successful self-test including the clearing of all DTCs is required in order to clear the manufacturing mode DTC. The manufacturing mode DTC
is:
-
B2477 (Module Configuration Failure)
1. NOTE: This step is only necessary if the GEM is being replaced.
Upload the module configuration information from the GEM into the scan tool. For additional information, refer to Information Bus.
2. NOTE: It may be easier to move/rotate the GEM to a lower position in order to access the 5 electrical connectors and their associated locking
mechanisms.
Remove the 2 screws and position the GEM to access the electrical connectors.
3. Disconnect the electrical connectors and remove the GEM.
Installation
1. Connect the electrical connectors.
2. NOTE: If the GEM is not being replaced, this is the last step that is necessary.
Position the GEM and install the 2 screws.
