Windstar V6-232 3.8L (1995)
Air Bag: Service and Repair
Driver Side Air Bag Module
WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment and
possible personal injury, the positive battery cable must be disconnected prior to servicing or replacing any system components.
REMOVAL
NOTE: If the driver side air bag module did not deploy in a collision. it may not have been needed. Complete all diagnosis before replacing the
driver side air bag module.
1. Disconnect battery ground cable.
2. Disconnect positive battery cable and wait one minute for backup power supply energy to be depleted.
3. Pry out two plugs covering air bag module screws on sides of steering wheel.
4. Remove two air bag module retaining screws on side of steering wheel from driver side air bag module and lift module away from steering wheel.
