ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Fuel Gauge - Does Not Read over 3/4 Full|Page 1261 > < Fuel Gauge - Does Not Read over 3/4 Full
Page 2
background image

^

Frayed wire in B-pillar footwell area. Refer to Figure 1.

^

Shorted fuel pump

Disconnect C-412 near the fuel pump and install an ammeter in series with the pump in Circuit 787 (PK/BK). If the current exceeds 8 amps, the pump is
shorted and must be replaced. Do not replace the pump if the ammeter reads less than 8 amps.

If a wiring short is found, repair as outlined in Section 18-01 of the appropriate Windstar Service Manual and return the vehicle to the customer.

^

If no short is found, go to next Section.

^

If the fuel pump is the cause of the short, replace the fuel pump and go to the next Section, Step 4.

IF FUEL GAUGE READS 3/4 FULL AFTER TANK HAS BEEN FILLED OR THE TANK IS SLOW TO FILL PAST 3/4

The Windstar fuel level gauge utilizes electronic circuitry to delay or dampen its response to changes in the fuel level. This is to prevent the fuel gauge

Fuel Gauge - Does Not Read over 3/4 Full|Page 1261 > < Fuel Gauge - Does Not Read over 3/4 Full