Windstar V6-232 3.8L (1995)
Clamp Positioning
Boot Clamp Tightening
9. On inboard driveshaft joint boot, position boot clamp as shown.
10. On both driveshaft joint boots, tighten boot clamp using boot clamp pliers D87P-0.098-A, or equivalent.
11. Install new retainer circlip in groove nearest end of interconnecting shaft, noting the following:
a. Do not reuse retainer circlips. Replace with new retainer circlips before assembly.
b. Start one end in groove and work retainer circlip over interconnecting shaft and into groove.