ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Speed Control Deactivator Switch > < Speed Control Cable

Windstar 1995 (10.1994-07.2000)

Speed Control - Speed Control Switch Windstar 1995 (10/1994-07/2000)
Removal and Installation

Removal

  1. Disconnect the battery ground cable.

  1. CAUTION:
    CAUTION:When separating the speed control actuator switch from the steering wheel, it is necessary to take precautions not to damage the steering wheel.
    NOTE:
    NOTE:Standard actuator switch shown, optional actuator switch similar.
    Pry the speed control actuator switch out of the steering wheel.

  1. Remove the speed control actuator switch.
    1. Disconnect the speed control actuator switch electrical connector.
    1. Remove the speed control actuator switch.

Installation

  1. NOTE:
    NOTE:When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn its strategy.
    To install, reverse the removal procedure.

Speed Control Deactivator Switch > < Speed Control Cable