Metro L3-61 1.0L (1990)
Engine Control Module: Service and Repair
NOTE: To prevent possible Electrostatic Discharge damage: DO NOT touch the ECM connector pins or soldered components on the ECM circuit
board. Service of the ECM consists of complete replacement for the ECM. There are no serviceable parts, such as a PROM or Mem-Cal to replace inside
this ECM. If the ECM is determined to be faulty, it is then to be replaced as a complete assembly.
IMPORTANT: When replacing the production ECM with a service ECM, it is important to transfer the broadcast code and production ECM number to
the service ECM label. This will allow positive identification of the ECM parts throughout the service life of the vehicle.
REMOVE OR DISCONNECT:
1.
Negative battery cable.
2.
Passenger compartment fuse block.
3.
3 fasteners from ECM bracket.
4.
ECM connectors (2).
5.
ECM from passenger compartment.
INSTALL OR RECONNECT:
1.
Connectors (2) to new ECM.
2.
ECM into underdash location.
3.
3 fasteners to ECM bracket.
4.
Tighten securely.
5.
Fuse block to mounting bracket.
6.
Negative battery cable.