Metro L4-079 1.3L VIN 9 TBI (1995)
Air Bag Control Module: Service and Repair
WARNING: The diagnostic energy reserve module (DERM) can maintain enough voltage to cause air bag deployment for up to ten minutes
after the ignition switch is turned off and the battery is disconnected. Servicing the SIR system during this period may result in accidental
deployment and personal injury.
1. Disarm system as described in Air Bag System Disarming & Arming.
2. Remove center console.
3. Remove Connector Position Assurance (CPA), then disconnect SDM electrical connectors.
4. Remove SDM attaching bolts, then the SDM.
5. Reverse procedure to install, noting the following:
a. Install SDM with arrow pointed toward front of the vehicle.
b. After completing installation, rearm system as described in Air Bag System Disarming & Arming.
c. Turn ignition switch to On position and verify that the AIR BAG or SIR warning lamp flashes seven to nine times and then turns off. If lamp
does not respond as specified, refer to System Diagnosis.
