Spectrum L4-91.5 1.5L (1989)
8.
Remove axle to body attaching bolts, then lower rear axle assembly from vehicle.
9.
Reverse procedure to install, noting the following:
a. When installing coil springs, the thinner end of spring must be attached at upper end and the bottom of spring must be positioned as shown,
Fig. 3.
b. Rear trim height, Fig. 4, must be set to 15.2 inches prior to tightening rear axle bolts.
c. The lower shock absorber attaching bolt is coated with an adhesive agent and should be replaced whenever removed.
