Tracker 4x2 L4-1.6L VIN 6 (1995)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Engine Coolant Temperature Sensor Location
ENGINE COOLANT TEMPERATURE SENSOR REPLACEMENT
NOTICE: Care must be used when handling the Engine Coolant Temperature (ECT) sensor. Damage to the ECT sensor will affect proper operation
of the fuel injection system.
REMOVE OR DISCONNECT
^
Drain coolant system. Refer to Cooling System / Service and Repair.
1. Negative (-) battery cable.
2. ECT sensor electrical connector.
3. ECT sensor from intake manifold.
INSTALL OR CONNECT
1. ECT sensor to intake manifold. Tighten ECT sensor to 12.5-17.5 Nm (9.5-12.5 lb. ft.).
2. ECT sensor electrical connector.
3. Negative (-) battery cable. Tighten Negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
^
Replenish coolant system to proper level. Refer to Cooling System / Service and Repair.