Tracker 4x2 L4-1.6L VIN 6 (1995)
Fig. 35 Camshaft Carrier Cap Bolt Tightening Sequence.
f.
Gradually tighten camshaft carrier cap bolts in order,Fig. 35, to specification.
8. Apply clean engine to camshaft seal, then install seal in cylinder head flush with carrier surface.
9. Install timing belt inside cover to cylinder head and tighten to specification.
10. Install rocker arm shaft plug into cylinder head and tighten to specification.
Fig. 36 Camshaft Timing Belt Gear Alignment.
11. Align dwell pin with slot in camshaft timing belt gear, Fig. 36, then using tool No. J41840, or equivalent, install camshaft timing belt gear on
camshaft and tighten to specifications.
12. Install timing belt. Refer to Timing Components / Timing Belt / Service and Repair.
13. Apply silicone to base of distributor case, Fig. 29, install and tighten to specifications.
14. Install distributor.
15. Adjust valve lash. Refer to Valve Clearance / Adjustments.
16. Install valve cover. Refer to Valve Cover / Service and Repair.
17. Install radiator. Refer to Cooling System / Radiator / Service and Repair.
