Tracker 4x2 L4-1.6L VIN 6 (1995)
Fuel Pressure: Testing and Inspection
Fuel Rail Plug Bolt
Comp. Loc
FUEL SYSTEM PRESSURE TEST
A fuel system pressure test is a part of several diagnostic charts and symptoms checks. To perform this test, follow the procedure listed below.
TOOLS REQUIRED
J34730-1 Fuel Pressure Gage
J39021 Fuel Injector Tester
J39200 Digital Multimeter
J41011 Fuel Pressure Gage Adapter
PROCEDURE
1. Relieve fuel pressure. Refer to Fuel Pressure Relief Procedure under Service and Repair.
2. Remove fuel plug bolt from fuel rail (refer to image).
3. Install a J41041 Fuel Pressure Gage Adapter to fuel rail (refer to image).
4. Install a J34730-1 Fuel Pressure Gage to J410411 Fuel Pressure Gage Adapter (refer to image).
5. Reconnect negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
6. Start engine and idle at normal operating temperature.
7. Check fuel pressure as follows:
^
Idling - 210-260 kPa (30-37 psi).