Tracker 4x2 L4-1590cc 1.6L (1991)
4.
Position heat shield panel (1) to floor pan so embossment on heat shield panel is aligned with # 1 body hole. Panel-to-side frame clearance is
approximately 15 mm and panel-to-crossmember clearence is approximately 10 mm (see illustrations).
5.
Punch a 4 mm (5/32") hole into floor panel at each of four corner anchor holes of heat shield panel using the 20.5" long punch tool supplied
for this campaign. Tap punch tool several times with hammer until shoulder of punching tool contacts floor panel.
6.
Apply small amount of anti-corrosive sealer (such as GM 12345489) to threads of each heat shield screw (7) and install heat shield panel
using four screws.
7.
Install exhaust pipe loop (2) on heat shield panel using two exhaust pipe loop bolts (6).
8.
Lower vehicle.
9.
Install Campaign Identification Label.
Campaign Identification Label
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label."
Each label provides a space to include the campaign number and the five digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner. Additional "Campaign Identification Labels" can be obtained from DAC.
Apply "Campaign Identification Label" only on a clean, dry surface.
Claim Information
Submit a Product Campaign Claim with the information indicated.
Dealers will automatically receive the correct labor and material allowance based on the labor operation performed.
Refer to the Chevrolet Claims Processing Manual for details on Product Campaign Claim Submission.
Owner Letter
May 8, 1992
Dear Geo Tracker Owner:
This notice is sent to inform you that Chevrolet Motor Division is conducting a recall campaign that includes your vehicle.
