geo Workshop Repair Guides

Geo Workshop Service and Repair Manuals

Electrical Specifications|Page 1697 > < Electrical Specifications|Page 1695
Page 2
background image

TEST DESCRIPTION:  Numbers below refer to circled numbers on the diagnostic chart.

1.

This checks for ignition voltage on BLK/WHT wire at the O2 sensor.

2.

Checks the ground side of the circuit to the O2 heater.

3.

This will check the heater element resistance. The 3 to 5.5 ohms range is at 23°C (73°F).

DIAGNOSTIC AIDS:

Check for poor connection and corrosion at the O2 connector for intermittent operation of the O2 heater circuit.

Electrical Specifications|Page 1697 > < Electrical Specifications|Page 1695