Tracker 4x2 L4-1590cc 1.6L (1991)
Throttle Position Sensor: Service and Repair
REMOVAL:
1.
Disconnect electrical connectors.
2.
Remove the TPS attaching screw assemblies and retainer, (if applicable).
3.
Remove TPS from throttle body assembly.
NOTE: The TPS is an electrical component and must not be soaked in any liquid cleaner or solvent, as damage may result.
INSTALLATION:
1.
Install TPS to throttle body assembly, while lining up TPS lever with TPS drive lever on throttle body.
2.
Install the two attaching screw assemblies. Tighten screw assemblies to 2.0 N-m (18.0 lb. in.).
3.
Install electrical connector to TPS.
4.
Adjust the TPS as per specification. Refer to Powertrain Management/Computers and Control Systems/Throttle Position
Sensor/Adjustments.